Vehicle-Identification

Vehicle-Identification

The Value-ID Long Range Identification system is ideally suited for comfortable access control in professional parking management but also for corporate parking lots and residential parking.

Comfortable

A Transponder placed behind the windscreen is being read by theValue-ID Reader when the vehicle approaches the Reader antenna. Each Transponder has its unique identification code and can therefore be used for uniquely identifiy the vehicle respectively its driver. If the Transponder has the necessary access rights, access is granted and the barrier will be opened. The wather proof Reader with directional antenna can be used for inside as well as for outdoor use.

Connectivity

A great variety of up to data interface options is available: RS232, USB or Ethernet. This allowas interfacing to virtually any management system. The optional use of power over ethernet simplifies installation and reduces investment cost. Integration of the Value-ID equipment in solutions for parking management, facility management and access control can be accomplished with little effort.

Integrated intelligence

The series 3000 Readers can optionally be operated in Stand- Alone mode. This means that the application logic runs inside of the device. This way, the access to doors or car barriers can be checked easily. The access rigths can be assigned by a Whitelist which is integrated in the Reader.

Optionally the Reader can be equipped with an Input/Output module providing two Relay outputs and two Opto-coupler inputs. This allows direct control of physical barriers.

Multi-Reader

Multiple Readers can be operated in close proximity to each other without any negative interference.

Energy efficient

With an energy consumption of only 0,25W the Value-ID active RFID system operates extremely power saving.

Secure

The Transponders and Readers have an integrated AES-standard encryption which can be enabled optionally. Thus it is impossible to eavesdrop the user data or to manipulate data transmission.

Over The Air Kommunikation

Over The Air communication

A unique feature of the Value-ID Reader 3000 is its „Over The Air (OTA)“ communication ability. The RF interface will be used for communication between readers in this case. A gateway Reader will provide a virtual connection between a PC and a remote Reader. This way it is possible to install Readers without expensive and time consuming installation of network cables.

Investment protection

IT systems must meet theyr requirements also in the future. Thus the Operating System of the Reader (the “Firmware”) of all System 3000 Readers is updateable. The Firmware Upgrade is done using the standard communication interface or simply “Over The Air”. So it is not necessary to unmunt a Reader for doing a Firmware update. A special safety mechanism maintains an operable state of the Reader even if communication during update is being interrupted or if a power failure occurs.